Franke Cube 26.6-in. x 17.7-in. 18 Gauge Stainless Steel Undermount Single Bowl Kitchen Sink - CUX11025

Maximum Bowl for a 30" Base Cabinet

Want the biggest single bowl a 30" cabinet can take? The Franke Cube CUX11025 stretches to 26.62" outside, giving you a 25" long, 9" deep basin, roomy enough to wash a roasting pan or a full-size cutting board without angling it.

Its crisp, nearly square corners make the floor of the sink usable edge to edge, and the rear drain keeps that floor clear in the middle where you actually work. Underneath, sound pads and a spray-on coating keep the clatter of dishes and the hum of a disposal down.

If you prefer more countertop around the sink, the 24.56" CUX11023 fits the same cabinet with a slightly smaller bowl.

RESOURCES

Specification Sheet
Franke Warranty

FEATURES

• Size: 26.62" x 17.75" outside, with a 25" x 16.12" bowl that is 9" deep
• Fits: a 30" or wider base cabinet
• 18 gauge stainless steel: thick enough to resist dents and flexing under heavy pots
• Pearl finish: a soft brushed sheen that hides fine scratches and water spots better than a mirror polish
• Quiet: sound-dampening pads plus an undercoating cut the drumming of running water and the rattle of a disposal
• Rear drain (3.5"): the sloped floor carries water to the back, keeping the center of the bowl clear and freeing up cabinet space for a disposal or pull-out bins
• No faucet holes: the faucet mounts in your countertop or on the wall, so you choose its exact placement

Q&A

What is the difference between this and the CUX11023?

Both fit a 30" cabinet. This one has the larger bowl (25" long vs 23"); the CUX11023 leaves more countertop around the sink.

Is there a matching grid?

Yes. The Franke CU25-36S grid is made specifically for this sink.

Can I install it with a laminate countertop?

No. Undermount sinks need a solid countertop, such as granite, quartz, marble or solid surface, because the sink hangs from the underside of the counter and the cut edge stays exposed. Your fabricator cuts the opening using the template on the spec sheet.

DETAILS