Franke Cube 31.5-in. x 17.7-in. 18 Gauge Stainless Steel Undermount Single Bowl Kitchen Sink - CUX11030

A Generous Single Bowl for 36" Cabinets

Do you cook big, entertain often, or simply hate washing pans in two halves? The Franke Cube CUX11030 fills a 36" sink base with a 30" long, 9" deep bowl, the largest in the Cube range.

At this size you can soak a full broiler pan, wash a large cutting board flat, or rinse produce in a colander while dishes wait at the other end. The squared Cube corners keep that space usable right to the walls, and the rear drain keeps the working area in the middle clear.

Looking for a full workstation? The CUX11030-WKC is this same sink bundled with a grid, strainer and Franke's All-In accessory set.

RESOURCES

Specification Sheet
Franke Warranty

FEATURES

• Size: 31.5" x 17.75" outside, with a 30" x 16.12" bowl that is 9" deep
• Fits: a 36" or wider base cabinet
• 18 gauge stainless steel: thick enough to resist dents and flexing under heavy pots
• Pearl finish: a soft brushed sheen that hides fine scratches and water spots better than a mirror polish
• Quiet: sound-dampening pads plus an undercoating cut the drumming of running water and the rattle of a disposal
• Rear drain (3.5"): the sloped floor carries water to the back, keeping the center of the bowl clear and freeing up cabinet space for a disposal or pull-out bins
• No faucet holes: the faucet mounts in your countertop or on the wall, so you choose its exact placement

Q&A

What is the difference between this and the CUX11030-WKC?

It is the same sink. The WKC version adds a bottom grid, strainer and Franke's All-In accessory kit (colanders, bamboo board and more) in one bundle.

Is there a matching grid?

Yes. The Franke CU30-36S grid is made for this sink.

Can I install it with a laminate countertop?

No. Undermount sinks need a solid countertop, such as granite, quartz, marble or solid surface, because the sink hangs from the underside of the counter and the cut edge stays exposed. Your fabricator cuts the opening using the template on the spec sheet.

DETAILS